Coyote Pump Protectors

The Coyote Pump Protector protects pump motors by automatically shutting them off when they are at risk of low or high voltage, overload, rapid cycling, or running dry. Four models are available to suit your specific needs.

• Easy to install

• Automatically resets itself if turned off

• Protects both 2 & 3 wire motors from 1/3 to 2 HP

• Protects pumps by shutting them off due to:

Failure to pump fluid due to gas or air lock, clogged inlet, or lack of fluid, low voltage, high voltage, rapid cycling overload

• Restarts automatically with adjustable timer

• Inside wiring is sealed from outside elements

• Exceptional flexibility

Operates alone, with pressure or float switches, or tank pump-up controls

FEATURES

Super

115V 1/3-1HP model:

230V 1/3-2HP model:

Protects against running dry, too low or too

high of voltage, overload, and rapid cycling.

Also allows users to activate an alarm.

Basic

115V 1/3-1HP model:

230V 1/3-2HP model:

Protects against running dry and low voltage.

Pump Protectors

Coyote Pump Protectors Specifications

Coyote Pump Protector Super Models: 115 Volt & 230 Volt

Horsepower rating ..................1/3-1HP (115V), 1/3-2HP (230V)
Alarm ..........................Able to activate a light, bell or most any other alarm desired. The Coyote dry alarm contact is normally open, but will close on any fault condition.
Random start............................When powered at the circuit breaker or fused disconnect, a delay of 4 to 10 seconds occurs before the
Coyote turns the pump on. This prevents several pumps served by a single power source from all restarting at the same instant when power is restored after power outage.
Underload or lack of fluid: The Coyote shuts off the pump within one second of running dry and automatically restarts the pump after a designated amount of time (1 minute to 12 hours).
Trip delay ............................1 second
Reset delay ........................adjustable; 1 minute to 12 hours
Overload: The microprocessor circuit notes the normal running current of the pump motor. If the Coyote shuts the pump down due to excessive current, it will restart it in 60 seconds. If at that time the motor draws normal current, then the Coyote will allow it to run. If however, the motor continues to draw excessive current after two consecutive attempts, one minute apart, the Coyote locks out the pump so as not to burn out a motor winding. The overload light then changes from steady to blinking.

Trip amps ............................150% of normal load
Trip delay ............................1/4 second
Reset delay ..........................60 seconds
Voltage Fault: +2%
Trip delay ............................2 seconds (both models)
Reset delay .........................60 seconds (both models)
Voltage trip..........................95V (115V),1 90V (230V),135V (115V), 270V (230V)
Voltage reset ......................100V (115V), 200V (230V), 130V (115V) ,260V (230V)
Coyote Pump Protector Basic Models: 115 Volt & 230 Volt

Horsepower rating ...............1/3-1HP (115V), 1/3-2HP (230V)
Trip delay .............................1/4 seconds
Reset delay ...........................adjustable; 5 minutes to 5 hours
Operating temperature ..........-20º to 75º
Trip % of normal load ............adjustable
Voltage trip ............................110V (115V), 190V (230V)
Voltage reset ..........................106V (115V), 202V (230V)